两个人看的WWW在线观看_国产精品久久久久精品香蕉_老头天天吃我奶躁我的动图_亚洲成AV人片在线观看无

 學習下耐電弧試驗機的操作步驟

操作步驟:

1. 拉開有機玻璃門,放置好電極與試樣,用測量塊測量好兩個電極之間的距離并固定住兩個電極;連接上高壓端的高壓線與低壓端的地線,連接好試驗主機與實驗室的接地線,關上有機玻璃門(注意:如果門沒有關好,按下試驗按鈕不會響應);

2. 打開試驗主機電源并預熱10—15分鐘(注意:試驗主機與電腦的電源不能公用一個電源),初始狀態為停止按鈕上的紅色指示燈亮,試驗按鈕上的綠色指示燈滅;打開電腦,準備試驗;

3. 打開耐電弧實驗軟件,設置試驗參數;

4. 按下“試驗按鈕"(綠色指示燈亮,紅色指示燈滅),點擊“10mA 1/8通7/8段"(即階段1),當60s后自動停止高壓(注意:綠色指示燈是亮的,試驗時間不可更改不要拉開有機玻璃門),再點擊“10mA 1/4通3/4段"(即階段2),當60s后自動停止高壓,再點擊“10mA 1/4通1/4段"(即階段3),當60s后自動停止高壓,再點擊“10mA 連續"(即階段4),當60s后自動停止高壓;再點擊“20mA 連續"(即階段5),每個實驗階段的試驗時間為60s,60s后如果試樣沒有擊穿,接在點擊“30 mA 連續"(即階段6)如果60s后沒有擊穿,再點擊“40 mA 連續"(即階段7)60s后停止,按下“停止按鈕"(綠色指示燈滅,紅色指示燈亮);

   如果試樣在某個階段被擊穿,這時實驗人員需要點擊“結束試驗",并按下“停止按鈕"(綠色指示燈滅,紅色指示燈亮)來停止試驗,拉開有機玻璃門更換試樣,重復上述步驟試驗;

   一組試驗為5次,做完一組實驗后如需保存請點擊“保存文件",保存后再點擊“下組實驗"接著做下一組;

注意事項:

1. 嚴禁試驗主機與實驗室的地線不接就直接開始做試驗;

2. 不要在實驗時打開有機玻璃門;

3. 嚴禁試驗主機電源與電腦的電源共用一個;

4. 嚴禁熱插撥串口通訊線(正確操作為,關掉試驗主機電源再拔下通     ;    訊線);

5. 如果試驗中有事需要離開,請點擊“結束試驗"并按下紅色“停止按鈕",關掉試驗主機電源后再離開;

6. 主要適用范圍及功能:

7. 本試驗機是按照GB1411-2002 、IPC650、IEC61621、ASTMD495設計制造,并符合JEC149、UL746A等試驗方法。應用于電機、電器和家用電器等行業的電工用塑料、樹脂膠和絕緣漆等絕緣材料的耐電弧性能評定。主要適用于固體絕緣材料如:塑料、薄膜、樹脂、云母、陶瓷、玻璃、絕緣油、絕緣漆、紙板等介質的耐電弧性能測試。

8. 技術參數:

9. 1、輸入電壓:交流 220 V

10. 2、輸出電壓:30KV 

11. 3、電器容量:3 KVA

12. 4、試驗方式:間歇電弧,連續電弧

13. 5、試驗電流:10MA-20MA-30MA-40MA可選

14. 6、試驗電壓控制誤差: ≤ 1%

15. 7、電弧通斷時間誤差:  <5ms

16. 安全防護措施:

17.  (1)短路保護
     (2)安全門開啟保護
     (3)軟件誤操作保護

?